Installing Evo-All & THAR-MAZ1 on 2017 Mazda CX-5.
Followed the guide (62391/66311... different guides if going through troubleshooter vs Flash Link guide) for firmware & options (tried firmware 85.12 & 85.11)
THAR-MAZ1 only has Start/Stop 2nd connector (24 pin) & no 32 pin connector. So I am using the recommended wiring connections minus Data Key & Door Lock Data (A10 & A20)
When programming I cannot get the module to recognize a key (blue LED, no yellow LED illuminated when ignition is turned on).
Is the Data Key (A10) required? It is not in the THAR-MAZ1 harness nor is it populated in the OEM female connector.
One of the keys to this vehicle was lost previously & only have 1. Is it possible to program with only one key? (the Flash Link Manager notes that 2 keys are required. I don't quite understand why)
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
