I was installing the fort-1 in my 2011 escape and it went ok until key decryption. I updated firmware, set options and plugged it all in with the T-Harness. The evo-all would flash about 18 times with all 3 lights but then wouldn't go solid green or turn red (unless plugged into the flashlink updater) and the car would still start with the key. I connected the green and white wire to a ground and the car dinged it's standard 3note ding, and now car wouldn't start at all even after I took all the fortin wiring out. All the lights still work, and the fab will lock or unlock, but I can't move the car and it doesn't respond to the key being inserted, the dash doesn't light up when turned on, and it doesn't start (I can't even shift into neutral to move it!).... I looked up related fuses and they were fine, then checked the other fuses until my fingers about froze and they all looked good. Please help. This has been frustrating and my landlord might not like my car where it is stuck for long...
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
