Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

Evo one won’t remote start but will let the car continue to run after starting the car manually..

2017 Subaru WRX. Won't Remote start. Manual Trans. The yellow wire on the main harness (T-Harness) that goes to the clutch wire does nothing when trying to remote start. But the car will continue to run after I turn the key off.

0

3 x pressing lock no longer cranks starter

Previously worked. Now the vehicle doesn't crank. It performs the normal Guage sweep as well as vehicle maintenance built in tests. No start though.

0

Ascent won't start after 3 x times lock press

2020 ascent push button start, evo one installed with T-harness. After 3 x times lock button press horn honks, park lights flash 3 times, and no start.

0

Car will not start

Subaru Legacy 2013

the installation and programming went well. All wires soldered and taped. Programmed the Dcryptor program no problem. Installed it back in did the set up on the remote start and never started but caused the engine light to come on. I'm using a RS370 EXCALIBUR remote start. I did the learn set up with the remote start it went well but the car never started but tried 3x the brake peddle never shut it off very strange 

sn 001A07093213 

0

2016 Legacy no start with remote starter

I installed the Evo One in my daughters 2016 Subaru Legacy Limited with the regular key. I used the "T" harness and wired it as described on the website. When Lock button is press 3 times, the parking lights flash 3 times. I red in the quick start guide that this means read mode disabled. But could not see where to diagnose this issue. Programming went fine, All the LED lights did as they were supposed to. Decrypting worked OK. There are no LED lights lit on the unit at any time while plugged into vehicle. None when hit lock button, none when key is on, Pressing lock 3 times does nothing, tried unlock, then lock 3 times and nothing. I did notice the security light on the dash glows very slightly inbetween flashes, and also with the engine running. I connected all the wires as per the wiring diagram The IMO wires are connected at the back of the fuse panel in the White/Blue wire. The Yellow loop is cut as this is an automatic vehicle. THANK YOU!

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue