Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

03/12/2024

 Mazda Kong Vang (250Pts.)

0

2013 CX-5 Cranks But Won't Start M/T

EVO-ONE. I have the THAR-ONE-MAZ3 harness. White cable for clutch bypass is connected. Not sure what's going on. I've tried changing the programmable output from 2.1 (default) to 2.2 (I think it should be this one?) and still no luck. It will try to crank for a few seconds, then shut off then tries again for a few seconds but won't start. Yellow jumper was cut when I received it, but it is currently twisted together until I verify what the issue is then I'll do a more rigid connection. I don't have the hood pin switch connected, my kit didn't come with it. Not sure if this is preventing it from starting or not. I have tried enabling and disabling A11 for this but still no luck with remote start. SN: 002B04 643579
Login to reply View 1 answer(s)

03/12/2024

 Mazda Engomar (330Pts.)

0

I want firmware vision 0.80 for remote starter and I want rest limit sn; 002B04 676425

I want firmware vision 0.80 for remote starter and I want rest limit sn; 002B04 676425 For Mazda 6 2016 and how can I make doors close when I put driver mode and when I put parking mode doors open
Login to reply View 1 answer(s)

23/11/2024

 Mazda Engomar (330Pts.)

1

PLEASE RESET EVO-ONE PROGRAMMING REACH LIMIT: SN : 002B04 676425 AND I CANT START BY REMOTE

PLEASE RESET EVO-ONE PROGRAMMING REACH LIMIT: SN : 002B04 676425 AND I CANT START BY REMOTE

Login to reply View 1 answer(s)

21/11/2024

 Mazda Engomar (330Pts.)

0

Doors setting for Mazda 6 2016

How can make Mazda 6 2016 in the D mode doors lock and the parking mode doors unlock and I want to close the doors when the car still running support me
Login to reply View 1 answer(s)

20/11/2024

 Mazda Jérôme Maheux (1760Pts.)

0

Mazda-3 2010 Manuel

Bonjour, j'aimerais savoir si ce serait possible d'avoir le guide d'installation d'un Evo-One pour un mazda-3 2010 manuel svp? Ça fait déja plusieurs année que je n'ai pas installé de démarreur dans cette voiture et c'est effacé de ma mémoire! Merci beaucoup !!
Login to reply View 1 answer(s)

16/11/2024

 Mazda Engomar (330Pts.)

1

Please reset EVO-ONE Programming reach limit: SN : 002B04 676425 and i cant start by remote

I tried to return old firmware but i can’t find it
Login to reply View 1 answer(s)

03/11/2024

 Mazda Engomar (330Pts.)

0

Please reset EVO-ONE Programming reach limit: SN : 002B04 676425 and i cant start by remote like when i buy it

Mazda 6 2016 Thank you
Login to reply View 2 answer(s)

03/11/2024

 Mazda Engomar (330Pts.)

0

Please reset EVO-ONE Programming reach limit: SN : 002B04 676425 and i cant start by remote like when i buy it

Mazda 6 2016 Thank you
Login to reply View 2 answer(s)

15/10/2024

 Mazda Dariusd84 (250Pts.)

0

Fuel level Evo start LTE showing 0% on 2017 CX-5

Hi, on the 2017 Mazda CX-5, the EVOStart LTE displays 0% in the app for the fuel level. Is there a fix for this or it’s not available for the vehicle?
Login to reply View 1 answer(s)

11/10/2024

 Mazda Rayek (130Pts.)

0

Harnais vient avec ou non ?

Je serait interessé d"acheter un kit evo one pour un mazda cx-5 mais je ne sait pas si le t harness vient avec le kit ou si je doit me le procuré a part car ce dernier nest pas achetable directement sur votre site
Login to reply View 1 answer(s)

23/08/2024

 Mazda David Fisher (130Pts.)

0

2022 Mazda CX5 Evo One + THAR-ONE-MAZ3 + RF 942 kit unable to open hatch with 942 remote

Unable to open hatch with the 942 remote trunk release button. Everything else is working fine. Is there a solution? 2022 Mazda CX5 Automatic Transmission
Login to reply View 1 answer(s)

21/08/2024

 Mazda Waheed (130Pts.)

0

2023 Mazda CX-5 Auto Hold & Cruise Control Does Not Work When Vehicle Started Remotely.

Hello everyone I just installed the Fortin Evo-One in my 2023 Mazda CX-5 and everything works fine except the Auto Hold feature & Cruise Control works but get warning lights. but only when the car is started remotely. When started normally, it works just fine. how i can solve this?
Login to reply View 1 answer(s)

29/07/2024

 Mazda Vladislav Prokopov (130Pts.)

0

EvoOne linkr LT2 app loses connection

Hi, I have EvoOne with Linkr LT2 installed on a 2019 Mazda cx-5 signature. Recently, the app would have trouble connecting to the car, it would be greyed out when trying to start engine and the icons would turn grey. It seems to happen intermittently,

Login to reply View 1 answer(s)

08/07/2024

 Mazda Irshad Byraub (130Pts.)

0

How do I increase my remote start run time?

Hello. I have a Mazda CX-9 2023 using Evo-One to remote start. The serial number is 002B04 215450. It's installed using THAR-ONE-MAZ3 - T-HARNESS. I would like to increase the run time to the maximum after I remote start the vehicle. How can I do that please? If the decryptor needs to be used, please reset it for me please. I may have reached the limit. Thanks

Login to reply View 1 answer(s)

27/04/2024

 Mazda Juan Fernando Dorado (210Pts.)

0

DCRYPTOR LIMIT FOR MY MAZDA 3 2021 PUSH TO START

My evo one dcryptor limit reached error is showing .please help reset

sn 002B04 237806

Login to reply View 1 answer(s)

03/03/2024

 Mazda Juan Fernando Dorado (210Pts.)

0

Start air conditioning on remote start mazda 3 2021

Hi, exist some option to start the air conditioned on the car with the remote start o the mazda 3 2021?
Login to reply View 2 answer(s)

03/03/2024

 Mazda Juan Fernando Dorado (210Pts.)

0

Start air conditioning on remote start mazda 3 2021

Hi, exist some option to start the air conditioned on the car with the remote start o the mazda 3 2021?
Login to reply View 2 answer(s)

15/12/2020

 Mazda Julian wiryo (130Pts.)

0

EVO-ONE - failed MA inspection after install 19 Mazda cx-5

Went for a state inspection a few days after install failed because weak battery that was my fault a light was left on in the cabin, went back a couple hundred miles later and massachusetts state inspection lists certain systems as not ready. Anyone else seen this caused by the evo install? Could I temporarily remove the evo and the harness for the purpose of the inspection and put it back without damage?
Login to reply View 2 answer(s)

22/02/2024

 Mazda Liam Dion (130Pts.)

0

Mazda 3 2018 - Evo One - Rear Defrost

I installed a Evo one in a Mazda 3 2018 push to start automatic with the Thar-One-Maz3 Harness with OEM remote (3x lock). I want to activate the rear defrost on remote start. I have activated the option 39. On wirecolor, it says that the rear defrost is "Positive". Two questions : - What option should I take for 25 ? (there are 6). - How I set the A13 wire to send positive signal ? - How do I wire the A13 ? Do I simply tap on the vehicule wire ? Thanks ! How can I activate the rear defrost ? On wirecolor, it says that the rear defrost is "Positive". I have activated the option 39. What
Login to reply View 1 answer(s)

14/02/2024

 Mazda Mmm Qqq (130Pts.)

0

Configure EVO-ONE to NOT allow driving off without keyfob in the car.

I've installed an EVO-ONE/THAR MAZ5 in my 2023 Mazda CX-50. It all works fine so far, EXCEPT there is no 'interlock' to stop you driving off without the keys once remote started! I can start the car from inside the house and unlock the car, but then forget the keyfob in the house and still drive off... thus leaving me stranded when I turn the car off at the other end! I also installed an EVO-ONE in our 2019 Mazda CX-5. In that car, the Fortin forces you to press the Start button before pressing the brake and shifting into gear. Not so in my CX-50 install. Is there a configuration option I can set to make the CX-50 behave the same way as our CX-5? (Please note, I do NOT want to have the engine shut off when I unlock/open the door!)
Login to reply View 1 answer(s)

11/02/2024

 Mazda Stack316 (290Pts.)

0

CX5 horn does not go off when evo one alarm is tripped 2021 THAR-ONE-MAZ3

2021 Mazda CX5 evo one, the horn does not go off when alarm is tripped I used the THAR-ONE-MAZ3. I chose car has oem alarm Use evo one Remote start and alarm I also reflashed and tried the same with car did not have oem alarm Once alarm is activate I see and hear the clicking on the dash, but the horn does not sound Ty
Login to reply View 1 answer(s)

10/02/2024

 Mazda Kevin Hunt (130Pts.)

0

Manual CX-5 Crank no start

2014 Mazda CX5 ; manual push to start ; Evo-one w/MAZ THAR ; SN 002b04 638289

Cranks but doesn't start. All fob functions work, car runs normally, and it goes into ready mode and shuts down after exiting. Won't autostart after getting out of the vehicle - what am I missing? Valet mode off.

Using default settings with the plug&play harness.

Firmware 85.14

A1 through A-10 : ON

A11 OFF ; B1 OFF ; C1 ON

D2 ON

D3-D5 : OFF ; D6 ON

Firmware 1.26

2 through 15 : option 1 (default)

16.5 ; 18.1 ; 19.1 ; 20.8 ; 21.2 ; 24.1 ; 25 (off) ; 26.1 ; 29.1 ; 30.1 ; 31.1 ; 32.1 ; 33.2 ; 34.1 ; 35.1 36.3 ; 37.1 ; 38.1 ; 39.1

Login to reply View 1 answer(s)

07/01/2024

 Mazda elloran97 (130Pts.)

0

EVO-One for 2011 Mazdaspeed 3 - Remote start starts the vehicle but immediately shutsdown after 1 second.

After I put my vehicle in ready-mode for my manual, push-to-start vehicle, my car will remote start properly, however, it immediately shuts off after about 2 seconds. Parking lights don't show any indication on why it shutdowns either. What could be the issue? I also noticed that the wiring diagram for installation have flipped wiring colors for 7A (Back Clutch Switch 2) and 7B (Front clutch switch 1). It says the Back clutch switch should have 2 cables, a WHITE and a BLACK cable, however, in reality it has a GREY and BLACK cable. Same thing with the Front clutch switch; diagram says it should have a GREY and BLACK cable but it they're WHITE and BLACK in my car... I have tried both of these wirings actually, and the problem still persists. Even if this is not the cause of the problem, which one is correct?
Login to reply View 1 answer(s)

27/12/2023

 Mazda Mmk005 (130Pts.)

0

Evo Start 2 not working with Evo one with T Harness Thar one Maz3

Hello,

I recently bought Evo start 2 for my Evo one which I have been using for more than 2 years on my Mazda cx 3 2019 with T harness. At that time I did not choose the app start option while programming the Evo one. Can some please help me where should i be connecting the Yellow wire. Does it goes into the A1. Also none of the other options like door unlock are not working. Do I have to reprogram the Evo one again. I know that the firmware should be atleast 1.21. When i push start from the app the green light on the evo start 2 is turning on but nothing is happening.

I have followed the following steps and it was not working.

Ignition ON - OFF - ON (While holding the brake?)

Press and release brake 4 times

Press and hold the Evo start button until green

Turn OFF Ignition

Thank you for reading any kind of help or suggestions is much appreciated 

Login to reply View 1 answer(s)

19/12/2023

 Mazda Luis RG (160Pts.)

0

Does remote starting affect how my car handles automatic gear shifting?

It's weird, I know, but every time I start my car remotely it doesn't shift speeds after "4", it just stays there revving close to 4000 RPMs. I have to change it manually. Any ideas why? Did I do something wrong or forgot to check some option? I used the wizard when I programmed the EVO-One. I have a Push-to-start automatic Mazda 3 GS and installed an EVO-ONE with the THAR-ONE-MAZ3 T-Harness and the EVO-START 2. Thanks!
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue