Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

IS THERE A DIRECT PLUG AND PLAY FOR ME?

PURCHASED FROM SONIC ELECTRONICS. AN EVO-CHR.T5. FOR A 2012 JEEP LIBERTY SPORT 4X4. CAN YOU HELP ME WITH THE WIRING OF THE 20 PIN ADAPTER? SERVICE #001A06 265839. IF YOU CAN BE AS SPECIFIC AS POSSIBLE. THANKS. FOR YOU TIME AND PATIENCE.

0

GM remote starts - Data Link devices?

When I bought my 2011 Silverado, I had them install remote start because they were giving me a good deal on it. I don't know the brand that Chevy uses, so I don't known if it is compatible with the Fortin Data link protocols. Also, where do they typically install the remote starters? I am kind of new to this. Thanks

-2

Evo All problems with 2014 Ford Escape - missing outputs

I have installed a python 1406 with an EVO ALL without the ford harness in a 2014 escape. I am using wire to wire connections and running firmware 4.18. The programming goes as expected as far as the leds on the fortin are concerned. Step by step, after programming the blue led portion, I am able to remote start the car and learn the tach signal. After programming the bypass, I am able to remote start without a key but the remote start shuts down due to no tach signal. At any given point, the car will unlock but not lock. I have verified that the negative lock signal is making to the fortin unit. I also do not have a hood pin signal coming from the fortin. I did not have a door pin signal either so i was forced to run a wire directly to the dome light, which I would prefer not to have. I have programmed the bypass with and without the dcryptor method with the same results. I have verified connections so I am thinking it is something in the evo-all unit itself. Please help.

-2

Evo All problems with 2014 Ford Escape - missing outputs

I have installed a python 1406 with an EVO ALL without the ford harness in a 2014 escape. I am using wire to wire connections and running firmware 4.18. The programming goes as expected as far as the leds on the fortin are concerned. Step by step, after programming the blue led portion, I am able to remote start the car and learn the tach signal. After programming the bypass, I am able to remote start without a key but the remote start shuts down due to no tach signal. At any given point, the car will unlock but not lock. I have verified that the negative lock signal is making to the fortin unit. I also do not have a hood pin signal coming from the fortin. I did not have a door pin signal either so i was forced to run a wire directly to the dome light, which I would prefer not to have. I have programmed the bypass with and without the dcryptor method with the same results. I have verified connections so I am thinking it is something in the evo-all unit itself. Please help.

0

UNDER STANDING WHAT WIRES TO HOOK UP?

HI THERE HAVE A 2004 FORD FOCUS. I BOUGHT THE EVO-ALL BY PASS, I AM HAVING A HARD TIME UNDERSTANDING WHAT WIRES HAVE TO BE HOOKED UP. THE CHART SAYS AS PER THE VEHICLE 1A,C. I ALSO HAVE BOTH KEYS AND THE REMOE STARTER IS ALL WORKING AND HOOKED UP. JUST THEFT LIGHT KEEPS GOING ON AND WILL NOT REMOTE START. ANY HELP ??THANKS

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue