Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

06/12/2015

 Kia eric desjardins (130Pts.)

0

Kia forte don't crank exterior lights flash

When pressing on the remote the exterior lights flash like the car would like to start but nothing happen. Constated that the 3 light of the fortin coupe dosen't light, except the yellow light of the ignition when key is on but engine off. The only information I got from the troubleshoot was the verify the power ground of the module, ground and 12v is there. All other options work fine on it. Saw three fuses under the dash and nothing blown. Need more infos the continue troubleshoot thanks. The module installed is fortin evo-all -Eric
Login to reply View 1 answer(s)

04/12/2013

 Kia Vyacheslav Abramov (170Pts.)

0

Evo-All Module don't work propertly in kia soul 2013 (part 2)

Thank you for your answer. Probably I had found a possible reason, but know I don't know what to do.

I have disconnected the blue wire from my car alarm system, and I to put it mannually to the car ground before I do the start command  from my car alarm. And after that EVO-ALL module works all the time when I start my car via car-alarm (but I need every time before I start it disconnect and connect again the blue wire of EVO-ALL to the ground). And after that I tried more times to simulate possible reasons, and when I connect ignition earlier than GWR I see the same thing: I see the yellow and red leds are light and bypass doesn't work.

To connect EVO-ALL I use out in my car alarm that especially designed for bypass modules. Bellow that text the picture with my car alarm signals diagramm. And I think that delay between GWR and ignition isn't enough and EVO-ALL needs more time to swith on the bypass scheme.

What can I do to work Evo-All properly. Thank you.

 

Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue