Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

03/12/2024

 Honda David Stern (130Pts.)

0

2012 Civic starts then stops three times

Hello, I have had a remote start on my 2012 Honda Civic for 5+ years. It has quit working. It is a EVO-ALL and CrimeStopper RS00-G5. From following the troubleshooting I think it has to do with the tach signal but not sure what to check. The car will start for about 3 seconds then shut off. It does this three times and then nothing. While it is running the starter is engaged the entire time.
Login to reply View 1 answer(s)

25/10/2024

 Honda Daze (150Pts.)

0

13 honda accord push to start. Won't OEM remote start, automatic transmission

3x lock module shows blue light response to inputs from OEM key, electrical click and nothing. module shows yellow light when running started normally. Thar-one-hon3, Evo One. Firmware 73.30, function 38:2 is on. Unit option C1, D2 and D6 are on, Yellow loop wire is cut on module SN: 002B04680114
Login to reply View 1 answer(s)

03/07/2023

 Honda alhussain talal albraznji (160Pts.)

0

OL-RF-42-SST on Honda accord 2013 push to start.

i have problem with OL-RF-42-SST first time woked very well but when i unpluged the the wire and then i plug the wire again with evo one not working i try to program the kit again nothing happend the red led in the evo one flash but the antenna not flashing just when i plug the antenna flash 5 times then stope flashing i I tried every thing and every way possible but now the evo one not working i cant start the engine or any thing and red led under the yellow wires still going on not flashing but stay work please some help with this problem i reset the evo one same thing and now i am waiting for rest limit for the flash limet reset to program again and realy it's too much pain and time lost so please help me with fixing this problem
Login to reply View 1 answer(s)

03/07/2023

 Honda alhussain talal albraznji (160Pts.)

0

OL-RF-42-SST on Honda accord 2013 push to start.

i have problem with OL-RF-42-SST first time woked very well but when i unpluged the the wire and then i plug the wire again with evo one not working i try to program the kit again nothing happend the red led in the evo one flash but the antenna not flashing just when i plug the antenna flash 5 times then stope flashing i I tried every thing and every way possible but now the evo one not working i cant start the engine or any thing and red led under the yellow wires still going on not flashing but stay work please some help with this problem i reset the evo one same thing and now i am waiting for rest limit for the flash limet reset to program again and realy it's too much pain and time lost so please help me with fixing this problem
Login to reply View 1 answer(s)

13/05/2023

 Honda Lam Nguyen (160Pts.)

0

How to Wire Clutch Pedal Stroke Sensor for 2020 Honda Civic Type R

Hello I have the Evo-One and Fortin THARONE-HON7 T-Harness. Everything is wired up but I'm not sure how to create a relay to connect to the clutch pedal stroke sensor.
Login to reply View 0 answer(s)

25/02/2023

 Honda Neil Adamzak (180Pts.)

0

Would Low voltage cause the Evo ALL to not function?

I have a 2003 Honda CRV Remote Start setup using the CoolStart RS3-G5 and a Fortin EVO ALL - Recently the remote start has been Intermittently working, I noticed my Battery voltage has only been about 12.0 resting and when the remote start does not work... Is there a specific voltage these need to activate the remote start? Maybe I have a battery that is dying? Could lower voltage cause this? Thanks for any insight on this!!
Login to reply View 1 answer(s)

15/01/2023

 Honda Derek Meienburg (130Pts.)

0

EVO One 2020 Push To Start Honda HRV starts, shuts down, starts, then shuts down again

Using the thar-one-hon8 harness. Vehicle does not have a steering lock module so that is not connected. Updated to firmware stated in the guide and programmed Dcryptor. We are using the OEM remote with lock unlock lock to start. The vehicle will start and run for a few seconds before it shuts off. It then starts again, runs for a few seconds, and shuts off again. It does not attempt to start again after that.
Login to reply View 1 answer(s)

29/12/2022

 Honda Mark Matsko (130Pts.)

0

2016 crv wont start after program

I went throught the installation, held button and plugged in then hit 3x then turned ignition on and waited for blue flash then ran decrypter and installed and the car will not start with 3x lock.... they sent me a new module and same thing. Am i doing something wrong?
Login to reply View 1 answer(s)

18/12/2022

 Honda Sean Meehan (130Pts.)

0

2104 Honda Accord Remote Start does not work after programming and Installation

I have all the wires in place, have a toggle kill switch, programmed correctly and did the Flashlink Dcryptor. When I attempt to remote start, it does not start. I see a blue led light the controller when I hit lock on my key fob, but that's it. I have a 2014 Honda Acord Push Start. With the remote start in place, the car still operates as normal.
Login to reply View 1 answer(s)

03/11/2022

 Honda nick pavao (130Pts.)

0

No start after install

I've got a crime stopper rs4-g6 installed with the Honda sl3 fortin bypass on a 1998 Honda Accord, remote start only works if key is in the ignition, already tried to cut the blue/white data link wires same issue.
Login to reply View 1 answer(s)

08/04/2021

 Honda Annie Williams (130Pts.)

0

Engine doesnt start red light flashes

2014 Honda pilot
Login to reply View 1 answer(s)

13/12/2020

 Honda Natalie Maldonado (880Pts.)

0

Remote start standard key 2019 Honda civic not working

Evo One remote start T harness 2019 Honda civic standard key not working I followed the guide and I have the parking light and horn connected. I also have the fuse connected to the odb contact +. After doing the sequence and yellow and red alternate flashing, I disconnected the unit to use the decryptor and transferred the data. Everything seems ok and once I connected everything back, there is no blue light or any light on the Evo. I lock the car and after some seconds tried 3x lock, nothing happens, the Evo doesn't show any light at a!!. No remote start. When I turn the ignition on, the yellow light on the Evo is on (no flashing). Nothing else happens. Is there any other step needed that I am missing? Evo id: 002B04 107292 By the way, the firmware installed is the latest available Thanks in advance
Login to reply View 1 answer(s)

15/11/2020

 Honda Richard Weatherby (130Pts.)

0

New ECM/PCM installed now immobilizer does not recognize remote start.

this remote start has been functioning properly, but I had the ECM replaced by Honda and since then I can not remote start the car. I have attemped the reprogram several times to the same result, the immobilzer key flashes on the instrument cluster and the car just cranks but will not start. I tried it with the key in the ignition, hit the remote start and everything is as it should be. A started and running car. So, what is going on with the remote system?? thanks in advance for you assistance.