Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

Mycar not working properly with evo

Mycar Lt2 won't work properly on evo one I believe it's paired as I can send commands,shows gps,battery. So problem is if I ready car then later send start signal it will start run a few seconds then shut down and unready vehicle also when I send lock/unlock it sends it three times on either senario as well as it always shows green unlock doors in the middle no matter what state car is in volt and gps seem to work okay I'm trying to get this module up and running please

0

EVO-START2

Je viens d'acheter un Véhicule avec le EVO-START2 J'ai eu un nouveau code activation mais sa ne fonctionne pas... sa me dit qu' il est expiré mais je ne peux plus rejoindre l'ancien propriétaire donc voici ma question ???? Qu'est-ce que je dois faire maintenant ???? Quel est le procécus ???? Nathalie

14/11/2022

Honda Moike (580Pts.)

0

2010 HONDA RIDGELINE

evo one, wire to wire, connected all wires used guide # 86261. Programming problem, after the 10x red flashes the light shuts off and does not turn to blue. Checked all the wirings and they all got good contact. Also tried a different unit and same results. I did the troubleshooting guides and its mentioning the yellow wire on the 20 pin connector to ignition? which on the guide i used does not show use for that yellow wire.

0

EVO one on 2006 Honda Ridgeline stopped working and wont re-program, what can I do?

I had this working for a few years and just this fall i noticed no blue light on the antenna and no activity on the antenna when i push the valet button or antenna button. It has stopped functioning and was wondering if I can try to re-program, but i when i try to do the programing, i cannot get past the step where the 6 pin connector is plugged in and the red light lights up while pushinng the program button. I am not getting a red light. I have power (+12 volts) and ground on the 6 pinn connector. Is there anything I can do at this point? Is it toast? I can hook up the evo one to the flash link and access it and get the red light and make changes to options so it still works off the vehicle. Just cant seem to get it to program once plugged in.

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue