Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

14/05/2022

 Audi Sanpadi Ninsavang (160Pts.)

0

evo-all on 2009 audi s5 will not learn/decrypt key with T-harness

I have tapped all he correct color wires by the punch and twist method, The T-harness is fully seated into the keyport module. Per the guide I am using the recommended 60.10 firmware. when Igo through the process on learning/decrypting the key, the evo all only gets to the point where all there leds alternate. but instead of getting a solid red led and then the slowly alternating red and yellow. I only get the red led that blinks 3x. and it never changes. I have also tried the alternate firmwares [.08] through [.11] and have had the same results. I have put a brand new batttery in the vehicle and the remote as well. I tried programing the evo with the option A11 both on and off. What else can I try? serial# : 001A07321568 Best wishes,
Login to reply View 1 answer(s)

03/06/2019

 Audi Nathan Crim (180Pts.)

0

2009 Audi s5 manual evo-one with thar-audi blue led stays solid will not program

2009 Audi s5 manual transmission, keyport and start/stop button with evo-one with thar-audi t harness. The blue led stays solid when the ignition is turned on with the keyport and I am unable to program. I have checked the yellow starter wire connection to the clutch bybass and the connection seems solid. The 12v to the juction box is getting a reading and good. The can high and low are also connected good. The connection for the vehicle is clipped together and the plug for the evo-one is connected as well. The 16pin is also plugged into the keyport. When I plug the data cable in while holding the program button the led turns blue. I plug in all the other cables, insert the key, and press once WITHOUT pressing the brake. When I press and release the the program button the blue led remains on as if nothing has happened. Any help please?
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue