Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

22/11/2019

 Ford Josh P (150Pts.)

0

No Brake command to evo all?

Hi I installed an evo all fort4 in a 2008 ford escape. Everything went well it starts the car with lock unlock lock. But the vehicle will stay running even after the foot brake is pressed. I noticed the brake wire is only an output on the evo all, so hooking this up to the foot brake didnt seem to work. The only way to shut the vehicle off is either wait for the timer to expire or push lock unlock lock again. Is there anyway to make the evo all recognize the foot brake? I was contamplating putting a relay from the positve brake wire to ground the hood pin control, but I would much prefer it to recognize over CAN bus if I can. Thanks!!
Login to reply View 2 answer(s)

15/12/2018

 Ford Kyle Riggio (130Pts.)

0

Brake applied when engine running, engine stops and doors lock seconds after

When the remote start system is active (engine running), if I enter the vehicle and step on the brake pedal, the engine stops (as it should) then the doors lock. Why do the doors lock?
Login to reply View 1 answer(s)

12/06/2017

 Ford Ross Ogans (200Pts.)

0

2010 Ford Taurus brake kill wire

I have atempted to figure out how to hook up the brake kill if needed to shut down the remote start. Have the Evo-All with the T harness. i have attempted to ground the dk blue wire to see if tha will inhibit the remote start from starting. With the dk blue wire grounded right to the battery it will still start. I was going to use this wire for my brake kill, but cannot seem to get that to work. What wire do I need to hook up for a bake kill and where. Thank you all in advanced!
Login to reply View 1 answer(s)

21/05/2017

 Ford Matthew Meiser (200Pts.)

0

Parking Light Connection causes Remote Start to shut down and the brake code flashes

2012 Escape Limited model, installed the EVO-ALL with the T-Harness. Parking light connection made to the purple/white wire in the door sill area per the recommendatiopn in the manual via a relay. When remote starting, the vehicle starts, then shuts down a couple seconds later and flashes the red LED twice to indicate brake on. With this connection broken, remote start works as intended.
Login to reply View 2 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue