Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

EVO ONE Installation/Programming 2004 Ford Expedition

I have installed the Evo-One module and the wiring as follows: (Guide #22301) A1 of 20 pin harness (yellow) to E5 of 6 pin harness (pink) A10 of 20 pin harness (ight blue/black stripe) to RX (Pin 4) of igntion barrel connector C (gray/orange stripe) A11 of 20 pin harness (black) to Green wire for foot brake connector (above foot brake) A20 of 20 pin harness (light blue) to TX (Pin 3) of ignition barrel connector C (white/green stripe) E1 of 6 pin harness (white) to Brown wire of light selector switch E2 of 6 pin harness (orange) to accesory wire of ignition switch (black/light green stripe) E3 of 6 pin harness (red) to constant battery power of igntion switch (light green/violet stripe) E4 of 6 pin harness (black) to ground E5 of 6 pin harness (pink) to A1 of 20 pin harness and ignition wire of the ignition switch (dark blue/light green stripe) E6 of 6 pin harness (yellow) to starter wire of ignition switch (red/light blue stripe) When I go to program it, I get to the final step and the red doesnt flash ten times like its supposed to. I get to the red light, turn the ignition to RUN, then the lights show red and yellow. I wait three seconds then turn it to off, which goes back to a solid red. I pull the key out of the ignition, then reinsert and turn it back to RUN and the red light flashes once then stays solid red. I turn the key to off and pull it out of the ignition and the light stays a solid red. The firmware for the bypass is 4.18 which is recommended by the Flashlink Manager, but the install guide #22301 recommends 71.35. Could that be the problem? The remote start recommended firmware is 1.24. Could I have gotten the RX and TX wires not hooked up correctly? Do I need to run the Dcryptor? I ran the dcryptor as the intstructions said and it seemed to have worked. I'm not sure what I would need it for. Do I need to use the valet switch? If I want to install a hood pin, which wire do I connect it to of the 20 pin harness? If you could help me out I'd greatly appreciate it. Thanks.

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue