Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

Evo all/gmt4 module not connected/detected in flash manager

Evo all/gmt4 module not connected/detected in flash manager 4. It will recognize the flashlink2, i can upgrade the firmware, but the evoall/gmt4 unit is never recognized. I have a solid red light on the flash updater and a solid red light on the evo all in bypass mode, switch to remote start and the evo all has all the leds blinking a few times and it doesnt connect. when I shut down the program and restart it, the program recogognizes the updater plugged in but there is no firmware selected.

Update the firmware again and it accepts, and then every thing is the same as above. it seems like everything is communicating with the evoall flashing, but can never get unit connected throught the software. Is the module bad, servers down, bad flash tool? I tried a reset on the module again but same as above.

0

Flashlink updater 4 with viper

I have a Flashlink 4 Updater running current firmwear. I am trying to program an evo all module. When I am going through the steps in the Flashlink Manager and get to protocall Viper isnt an option. Can I not use an evo all with a viper 4806v?

0

Can't get into remote start mode in Flash-Link

Evo-All with GM V2 harness for 2011 Camaro SS. The Flash Link software will let me into the bypass settings but I cannot get into the remote start settings. It tells me that the unit is disconnected. I tried using the "special unit" and have had no luck. Also, when I programmed it, the finally step didn't seem to complete and I have a continuous blue light on the unit. Does that mean that my CAN wire isn't getting a good signal?

0

Can't get into remote start mode in Flash-Link

Evo-All with GM V2 harness for 2011 Camaro SS. The Flash Link software will let me into the bypass settings but I cannot get into the remote start settings. It tells me that the unit is disconnected. I tried using the "special unit" and have had no luck. Also, when I programmed it, the finally step didn't seem to complete and I have a continuous blue light on the unit. Does that mean that my CAN wire isn't getting a good signal?

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue