EVO-ALL (T-harness) with Linkr LT-2 RF antenna
2009 AUDI A4 with key-port, auto transmission
Step 8 . LEARN THE TELEMATIC DEVICE TO THE EVO-ALL
In order to communicate with the remote starter, the Telematic device must be learned to the EVO-ALL.
1- Disconnect the 4 pin power connector from the Evo-All.
2- Press and Hold the Programming button on the Evo-All while plugging back the Black 4 pin connector.
3- The LED’s on the Evo-All will begin to cycle. Keep pressing the programming button until the RED &
BLUE LED’s are On.
4- Release the programming button.
5- Press & Hold the programming button again for 5 seconds until the BLUE & RED LED’s comes back On.
6- Release the programming button and Cycle the ignition to the ON position.
7- The RED, YELLOW & BLUE LED’s will be ON.
8- At that same moment the RED & BLUE LED’s will blink once to confirm that the MyCar ID has been
learned to the Evo-All.
9- Cycle the vehicle’s ignition to the OFF position to Exit EVO-ALL programming
I can not get red, yellow, blue leds on after cycle ignition on. Only Red and Blue leds are on.
Selected C1, D1, H2 settings for evo-all. Not sure if I need to connect another wire from harness
So the app will not lock,unlock,start,stop.
The Linkr LT app is downloaded on phone, account created, added car. The RF antenna red, green leds are solid/connected to network.
The app antenna icon is green, voltage battery icon is green and shows voltage. Select GPS icon and shows current vehicle location.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
