Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

07/09/2021

 Audi Cleber Baldan (230Pts.)

0

EVO-ALL won't code after cluster removed

Hello.

I have an Audi A3 2016 PTS that has an EVO-ALL V7 installed through a THAR-VW1 harness and it all woked seamless for months, with very minor glitces.

In while AC maitenance; namely the front door air actuator, I had to remove the imstruments cluster to have more room to work. It was a major pain, but I got it done.

Then I decided to check for a newer suggested firmware of my EVO-ALL and found v64.09, from v64.05 I was currently using.

The Cluster removal happened early in my project and only about 7 hours later the car was all reassembebled with some with some expected DTCs present, that were easily cleared to 0 DTC. When installed, the cluster was 100% operaciotnal, as everything else in the car - I only had to ajust it's clock .

But EVO-ALL was dead.

I came to the conclusion that the unit was not programmed any more in the car, so Idecided to try re-programming it all over again, but it keeps on failling on step 13: The LEDs keep flashing in 5x groups.

Installation manual used  with RLINK: https://cdn02.fortin.ca/download/82471/evo-all_ig_reg_bi_aud-a3-s3_2015-2016_pts_tb_a_82471.pdf
q

And this troubleeshooting guide says this is Cluster Protection Mode.

https://fortin.ca/en/vehicles/audi/a3/2016-push-to-start/troubleshooting.html

I don't see any issues or error message in he cluster, or in the infotaiment system.

I already left the car with the battery ON for 20+ minutes, but the issue persists.

I tried flashing back the version I had before, and also a master reset, but the 5x RED is always the final result.

How can I fix this situation??

 

Can I get a hand please?

Login to reply View 1 answer(s)

16/10/2020

 Audi Maxime Bernier (130Pts.)

0

connection to evo-one

connecting the module to flashlink when prompt to do. message : an error ocurred if persist contact support team. what to do next?
Login to reply View 1 answer(s)

29/12/2019

 Audi Guy Purpura (210Pts.)

0

What does a solid red light mean on Evo One cant program Programming

I have a evo One for a 2010 Audi A4 Manual. All the wire are hooked up correctly, i was able to program the key data but when i went to dycrypt it it was doing it for an hour and a half and nothing happend. so i started the process over and now i just have a solid red light at alll times. No matter whaT I DO i cant seem to reset it, i tried the instructions with the valet switch but it was usless and also plugging in the data link and holding the button down with no success? i think the module is no good?
Login to reply View 0 answer(s)

ttom -->

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue