Hi,
I purchased the THAR-FORT1 Kit which comes with the EVO ALL and FORT1 T-Harness. I also purchased the FlashLink updater and will set the EVO ALL to D2D.
I would like to pair all of this with an Avital 4015L remote starter for my 2011 F-150 (I do not want to use the factory remote start protocol as my truck doesn't have power locks).
I would like to only use the D2D cable to connect to the Avital 4015L in order to cut down on wire clutter. I would like to know if the D2D cable is the only cable I need to connect between the these two.
I was looking at the wiring diagram for the EVO ALL with the FORT1 T-Harness and on the left side of the remote starter every cable is optional if D2D is used but on the right side there is parking lights which I don't care for so I wont be hooking up and Ignition. Doesn't the ignition communicate through D2D?
https://fortin.ca/download/94881/EVO-ALL_IG_RTA_BI_FOR-FSERIES-2011-2016_KEY80bits_D_94881.pdf
Wanted to know if I am on the right track here before I start the install.
Thanks!