Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

08/12/2019

 Ford Vít Švanda (140Pts.)

0

Ford Mondeo 2016 (push to start) - not started - 3 led flashes

Hi I have EVO-ALL (sn: 001A07051925) with firmware 4.01 and T-harness (EVO-FORT3).   I have connected 4-pin and 5-pin cable only. I use OEM remote.   The programming was successful (I think). Blue led was solid -> after push to start -> blue start to blinking rapidly (not only 10x, but blinking until turn off).   When I used LOCK 3x, then unit start blinking two times (red->orange->blue). After this two attempts blink red 3 times.   My configuration: A1, A3, A4, A7, A8, A9, A10, A11, C1, D1, D1.3, D1.6, D1.10, D6     Please help me.  

 

Login to reply View 1 answer(s)

04/08/2015

 Ford Sergey G (160Pts.)

0

Ford Mondeo Europe

All 4 CAN-bus connections were checked. The unit was master reseted. The unit being installed with a separate remote starter - security system (local brand) which has ground out for immobilizer bypass. And this out being connected to Fortin A8 connector. Security system has brake pedal and push-to-start button connections which start the vehicle as a regular start. And it's working great when the original key is inside the car. So, I need to bypass the immobilizer to have remote start. All other Fortin connections are the same as in the guide #14751 except parking light switch which is not needed for me as all external indications are going from the security system. During programming, when the ignition is ON (step 4) I have the blue light flashes 2x times, then the red light flashes 4x times then all together (door locks opens, head lights (low beam) and internal lights flashes one time) and after all of that the blue light flashes rapidly. The unit is not programmed. I also tried to program it with security system fully disconnected. The scenario is the same.
Login to reply View 1 answer(s)

03/08/2015

 Ford Sergey G (160Pts.)

0

Ford Mondeo Europe

Ford Mondeo 2015 Push-to-Start (Europe).

All wiring colors are the same as in the guide.

FORTIN connected as a Key bypass only (+12, GND, IGN, CAN1, CAN2, GWR to control).

Firmware 71.28

Hardware v.6

During programming I have five red flashes instead of ten and unit is not programmed.

Please advise. Thanks.

Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue