I installed an axxess evo-one and added the rf641w remote kit to my son's 2017 honda civic si with manual transmission. The install went okay and everything works. The problem I have is that I put the car in ready mode and after I test the remote start, the car starts fine. I drive the car and when I return and shut off the car I make sure that I leave it in nuetral and the parking brake is engaged. When I go to remote start the car again the lights flash 3x which means that the car is out of ready mode. I shut off the D3 command via the flash link as suggested by Derek but the problem remains. Does that mean that everytime I'm going to exit the car I have to go through the steps of putting the car in ready mode? If that is the case than I will remove the unit. Has anyone else had this problem?
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
