Hi, I just installed the EVO all (EVO-NIST1) and it does not work in my Nissan Quest, 2015. I put one in my maxima from purchased and programmed from the same company and it was easy and worked right away so I am familiar with the setup. I plugged in the Brake plug, diagnostic port and cable under the push to start being there is no key port, wired in the black/white wire from the EVO into the purple push to start wire as per the directions, Once i did all this i plugged the unit all in, slow blinking blue light and I tried it and the box never makes the "click" sound it should when i hit lock like in my maxima, I tried the remaining brown wire and was able to go through the programming with the key fob with no issues, the light then just slowly blinks blue and never works after 3 locks. any ideas? Maybe the initial programming before it was shipped didn't take? Not sure at this point. thank you!
I also just nticed the onstructions show the wires based on ""Quest (Without sliding doors)"" but my quest does have power sliding doors, so now what?
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
