After looking at the wiring diagram here for a 2009 Kia Sedona and comparing this to the hookup guide available from Fortin website I am confused as to which wires need to be hooked into the car on the Evo-All and which wires need to be hooked directly to the remote start module.
If I have this correct I THINK the Evo-All should hook to the Can-Bus and Can-Bus2, the ignition, and a Red data wire located near the ignition. Then the data-link wire should hook to the UltraStart module.
What I cannot figure out is what parts of the system will NOT be activated/controlled by the Evo-All module and will have to be wired from the UltraStart nodule directly.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
