I Installed and was able to program my Evo-One successfully after flashing it with Firmware 7.20 for the Bypass and Firmware 1.15 for the Remote Start. I am trying to use my OEM remote 3x to remote start the vehicle which I activated with the Flash-Link2 Module at 38.2. First of all, the Evo-one won't detect any door activity through my CAN-bus. I also connected the Purple wire from the Evo-one to the Blue/White in the vehicle and the Purple/White to the Gray wire to see if that would work but it didn't. I confirmed these connections by adding a ground to these points and activated the door locks. I'm using all of the connections on Guide #18861 (page 2) and several extra conections from the "Wire Color" guide including the IMI/IMO, Key Sense, Foot Brake, Horn and Headlights connections. The "Wire Color" Guide also has connections for PATS RX/TX , VSS and Tach, which I can't seem to identify at the Evo-One 20 pin connector (or maybe I don't need these connections). I have several questions: 1. Does my vehicle send door activity data through the CAN-Bus? 2. Is "OEM Remote 3x start" supported on a 2013 Tacoma (G-Key)? 3. Will I need to buy an RF remote kit to make this Evo-One work? 4. Am I missing any connections or do I have too many wires connected? I'm really frustrated and think I have a defective unit. It's been days since I have been trying to resolve this and am about to give up. Please HELP!
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
