The steps I followed:
- Plugged the 4 pin back of push to start button
- Plugged the 4 pin break pedal
- Plugged the 16 pin OBDII
After plugging those connectors I went with the key bypass programming procedure.
Pushing the lock key 3 times makes the module send commands to the car, but no success turning it on. And then the red light flashes a few times (if I'm not mistaking it's 3 times).
I did not connect those 5 other wires into the BCM, Driver kick panel or Push-To-Start Button because I thought that only connecting the plugs would be enough to get the vehicle started. Is this assumption right or I should connect all those other 5 wires to get the car started?
The following file is the installation guide so you guys can take a look and help me on it:
https://fortin.ca/download/74261/evo-all_ig_tsa_bi_nis1-sentra_pts_2013-2018_a_74261.pdf
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
