Following instruction 59421 to install a stand-alone system with THAR-FOR2, I get to step 9 in the key bypass programming section. The vehicle's ignition turns on, but the blue light never flashes rapidly.
I've confirmed that the firmware is 71.46, and the 3 wires (Light Blue, Light Blue/Black, and Yellow) that come from the T-harness are properly crimped to the wires going to pins A20, A10, and A1. (crimped, and applied adhesive lined heat-shrink)
The CAN connections were connected to the wires at the pins as depicted on page 4 of the instructions - I noticed an error in the instructions, pin 20 on the diagnostic connector had a solid blue wire, rather than White/Blue. This wire was going to pin 20, and was twisted with the white wire on pin 19. To confirm proper connections, with the connector unplugged from the Evo All, I measured resistance between C1 & C2 to be 62ohms, and between C3 & C4 to be 61ohms - consistant with a standard CAN network.
I've tried switching C1 with C2, I've also tried switching C3 with C4 - no improvement.
Any help to get past step 9 will be appreciated.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
