I am looking to Connect a Evo-All Stand Alone on a 2014 Jeep Patriot. I am following installation diagram C. When I bought this evo, it was preflashed and listed as only needing to connect the harnesses. I have not attempted any installation yet.
For the single wire connection coming off the 20 pin connector, I am looking for more infomation on the purpose of them to determine what is necessary and to allow me to locate the wires and troubleshoot any incorrect connections.
-For the 20 Pin Connector
i. Externial input (Start/Stop External control negative) - What is this and what would this connect to?
ii. Parking light out negative (this is the white/purple positive for 2014 jeep patriot) - Is this just to blink the break lights and would a relay be required to make this connection, if so is this connection necessary. If it is necessary would it connect to the red/purple wire (shown on wirecolor.com under parking lights)
iii. Hood pin/Valet switch (no valet switch for 2014 Jeep Patriot which is a hatchback) is this a necessary connection and if so, where would this connect to near stearing column (without running under hood to actual switch). The directions state that this is optional, dark blue (from 20 pin connector) with no polarity given. Wirecolor.com list this as negative black/pink (from the 20 pin connector), and has no location or pictures of the colors.
Yellow and Green/orange will be connected per instruction C.
Seller Flashed for Stand Alone T Harness
Hardware V6
Firmware Vr 74-19 (Seller may have updated it further)
Date 11/2015
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
