Hello,
I am installing an EVO-ALL in a 2012 ford fusion and using it as the standalone remote starter. When I go through the first section of the programming I hold the button until the blue light is lit and turn the key on. Everything looks good and the blue light starts flashing. then after a couple of seconds the blue light goes out and the yellow light turns on. At this point I try to do the remote start with the key in the ignition and it appears it is trying (dash lights come on, etc), but the car never tries to start.
Any advise of things to try? I have the module programmed with the current recommended firmware for the 2012 ford fusion, and I have also tried the beta firmware as well as an older firmware and still get the same results..
Thanks,
Chris
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
