Installing an EVO-CHRT 4 in a 2012 Dodge Ram pickup. After initial installation (connection of T-harness), unit does not finish programming procedure correctly. On first attempt during Step 4 of the programming procedure the blue LED remained lit with no flashing after key was turned to ACC and then turned off after turning key to ON/RUN. All lights remained off after turning key to OFF again. Remote start did not work. Repeated steps 1-3 three times with same result on Step 4/5.
After reading through help forums, saw the recommendation to reset the unit in case it had been previously programmed for another vehicle. This was done by programming to the red light on step 2 and then holding the program button until all three lights flashed.
Now, unit performs normally through Steps 1-3 but now flashes all three lights when turning key to ON, and does so more than three times. The continuity was checked with a voltemeter and there is no loss of power or ground on the 4 pin data connector. This isn't surprising considering this only occurred after resetting the unit. My best guess is the firmware was reset as well, but my understanding is that then the lights should only flash three times.
Thank you,
Brett
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
