Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

Evo-One RF CRIMESTOPPER RFALL642W FM RF

For the Evo-one with CRIMESTOPPER RFALL642W FM RF which rf kit do i program it for?

Is the same as "Fortin FM"?

 

Also, can the evo-one be used with an rf kit and Compustar Drone (DR-3400)? What do I need to program for to work with Compustar Drone (DR-3400)?

 

Thanks

0

Will the EVO-ALL work without data link

I have a 2012 Toyota RAV4 it does not have data link. Will I be able to install the evo all as a remote starter?

1

Horn blowing constantly when Evo-All data link is disconnected

Installed an Evo-All + Prestige APS-57E system on a 2015 Corolla S. I also enabled the Evo-Alarm function. Everything works perfectly. But I accidently noticed what I believe could be a bad unit issue...

 

If I disconnect the datalink connector of the Evo-All, the horn constanly blows.

 

I even disconnected ALL connectors from the Evo-All and connected just the Evo-All by itself to the 20-pin harness and the horn started blowing again?? I have never seen this happen before and am worried that if the vehicles battery was ever disconnected, the client's horn would just start blowing? 

 

Somehow, the Evo-All has an internal ground signal inside itself? I tried reseting it as well. I also disconneted the horn connector from the steering wheel column and the Evo-All would still send a ground signal to the horn wire and blow it.

 

Conencting the data-link conector stops this from happening the the Evo works fine again. Is this just a bad unit?

1

Horn blowing constantly when Evo-All data link is disconnected

Installed an Evo-All + Prestige APS-57E system on a 2015 Corolla S. I also enabled the Evo-Alarm function. Everything works perfectly. But I accidently noticed what I believe could be a bad unit issue...

 

If I disconnect the datalink connector of the Evo-All, the horn constanly blows.

 

I even disconnected ALL connectors from the Evo-All and connected just the Evo-All by itself to the 20-pin harness and the horn started blowing again?? I have never seen this happen before and am worried that if the vehicles battery was ever disconnected, the client's horn would just start blowing? 

 

Somehow, the Evo-All has an internal ground signal inside itself? I tried reseting it as well. I also disconneted the horn connector from the steering wheel column and the Evo-All would still send a ground signal to the horn wire and blow it.

 

Conencting the data-link conector stops this from happening the the Evo works fine again. Is this just a bad unit?

1

2007 Toyota Tacoma & EVO-RIDE: Dinging when door is open, but no key

EVO-RIDE Service Number: 000903020460 As soon as power is applied to the EVO-RIDE (through the data link cable), the car begins dinging as if there is a key in the ignition. It continues to ding as long as the ignition is off and the door is open. The remote start works, but all warning lights in the instrument cluster remain on even after key take-over. Owner needs to press brake to release the remote-start, then re-start vehicle with the key to resolve the warning lights. Module came with formware version 2.03. Tried re-flashing to 0.17 as recommended by technical support since it is supposed to resolve the "Toyota Key Sense" problem. Both firmware versions exhibit the same behavior. Remote start system is Cromestopper Cool Start RS3-G4, connected to EVO-RIDE through data link.

1

G-key and remote starters

Hi! Im sorry but, i got a problem. I have Toyota camry 2011 G-key and Evo-all, I live in Russia, and Russian Fortin specialist cant tell me about, have evo-all work with my car. So, can you give me answer? If i buy and install remote starter with Evo-all, it will be worked from my OEM key or not? Evo-all hardware - vr.6, firmware vr. 4.18. Remote starter what i want to buy is - Crimestopper RS4 G4 or RS1 G4 - it is datalink compability remote system?

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer