English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

Réinitialiser
Réduire tout
Tout développer
Réinitialiser
Réduire tout
Tout développer
picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question
LES + RECENTS A VOIR! LES + NOTÉÉS LES + RÉPONDUES LES + VUES

10/11/2018

 Nissan khaled Salamah (130Pts.)

0

2009 Nissan Maxima PTS standard Installation With RS4-G5 No brake light!!!

Hi, all wiring is done propery Evo All progrmmed correctly, but the remote starter will not crank as the brake light will not go on.taking into consideration that the white red wire is connected properly to the 12+ brake switch wire (lightgreen on this vehicle). upon diognostics when the remote starter is engaged the white red wire should show 12+ to turn on the brake, but it dosn't so I jumped this wire to 12v during start only and the vehicle starts fine. I swapped three Evo ALL Modules to eleminate the deffective module assumpton and the problem stayed the same. Please Help As this is an Urgent Need. I have the flash link updater if and programming might help.
Connectez-vous pour répondre Voir 1 réponse(s)

25/02/2018

 Nissan Chuyen Ngo (220Pts.)

0

How to insert the prewired pins (Green and white wires) into the back of BCM connector (green), any certain way?

How to insert the prewired pins (Green and white wires) into the back of BCM connector (green), any certain way? Is there a special tool to use?
Connectez-vous pour répondre Voir 1 réponse(s)

16/01/2018

 Nissan Fahad Alotaibi (260Pts.)

0

worked finally evo all - NIST1 maxima 2014 normal EVO red led?

Hi I spent 12 hours to finish. I just want to confirm if everything is correct and won't have an issue in the future. A4 GREEN A5 WHITE A15 DOOR PIN A19 PTS Parking light The red led in the EVO and yellow turn on after I remote start. It says for 7 min then the red led goes off. Is this normal? Thanks
Connectez-vous pour répondre Voir 1 réponse(s)

10/01/2018

 Nissan MaDgamEr (180Pts.)

0

2014 Nissan Maxima defrost, heated seats and steering wheel

Do any fortin modules allow for heated steering, rear window defrost, windshield defrost and heated seat triggering when remote starting on 2014 Nissan Maxima? I see it is offered on some vehicles. Reason I ask is I believe it is canbus triggered on the Maxima, is it not?
Connectez-vous pour répondre Voir 1 réponse(s)

06/02/2017

 Nissan David Watson2 (130Pts.)

0

Lights stay on even when car is off!!!

Bought the Fortin Evo for the max...flashed it...everything works but when the car is off and locked, all interior lights including the outside factory courtesy lights stay on! Any suggestions?
Connectez-vous pour répondre Voir 1 réponse(s)

20/03/2016

 Nissan Bill W (1850Pts.)

1

Does Evo-One starter firmware .51 have all the improvements that firmware 1.18 brought?

Is firmware .51 the same as 1.18 aside from the "lock only at brake tap" option being available through RF kit programming? I know .51 was made after the 1.18 release but I am not sure that means .51 is a built off of 1.18. I am primarily concerned about the temp sensor setting that was updated to a higher temp in firmware 1.18. My defrost works reliably with 1.18 but does not with the lower temp setting of all the previous firmware versions. I need to retain this functionality if .51 is going to be my only "solution" to that head light problem.
Connectez-vous pour répondre Voir 1 réponse(s)

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer