Dear Tech Support,
I bought an Evo-One for my 2015 Toyota Tundra, the truck has G-key and factory 3 buttons with Open, Close and Panic on it. I flashed the unit with firmware 79.47, and selected the options C1-OEM Remote Monitoring and D2-Unlock before/Lock after (Disarm OEM alarm) and hit save. Using wire diagram ver. 20171121 and after i configured the unit as mentioned options above and solder all wires. Follow the key bypass programming procedure, I completed steps 1-4 everything went well as exactly to Manufacturer's procedure described, put the key in On/Run for step 5 the only one LED flashing is the RED. Also, I noted when flash the unit, the options I saw on the unit are A1-A11, C1 and D2 and no others options like i did the Evo-All unit for my 2013 Lexus RX350 previously. Don't know what I did wrong but sure do need your guidance to resolve this issue.
Regards,
John
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
