Fortin EVO-ALL installed on a 2014 Dodge Dart. I did the install with a T-Harness, and purchased the Flashlink Updater 2 as well. I hooked everything up, and began to program the module. When I get to step 5 to program the key, I insert the key into the ignition and nothing happens. The red light does not illuminate, and the yellow light stays on. I've done a bit of research, and I have checked my lt blue wire and lt blue/black wire connections, and even checked for continuity through the t-harness connectors and I have continuity through the harness. I also tested the CAN-Bus by releasing on blue and turning on the key, and the blue light flashed and seemed to work correctly. After programming the CAN-Bus, pressing lock/unlock on my remote makes the blue light flash, and when I turn on my key, the yellow light comes on. I just can't get my key to program into the system. Any help appreciated.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
