Alright. Since the tech support number is busy again I'll try on here. 2010 Colorado installing an Ultrastart 3295. I've double and triple checked the connections to ensure I'm on the proper wires but it absolutely will not program properly (wiring style 8 program style 3). Steps 1 & 2 work (pretty hard to mess them up) but step 3 when I turn ignition to the on/run position the Blue LED turns off (so far so good), the Red LED turns on (also so far so good) but then the red LED never flashes, the blue one does however. I've tried just going to the next step (start and hold crank for 3 seconds) but the yellow LED never comes on to signal programming is complete.
FWIW, this is a very stripped down version of the colorado (work truck basically) w/ no power locks/windows/etc.
Chuck
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
