Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

No heated seats / rear defroster at or below 32 degrees

Have a 06 Trailblazer, with the INTSL- + installed. I have yet to see the heated seats or rear defroster turn on when the temperature is at 32 or below. Was I missing something when I hooked it up. I didn't use datalink when hook up to the alarm.

0

cannot get int-sl+ to work via data link

Using pro start ps04-g5 remote start system with fortin int-sl+ bypass on a 2006 silverado. Data link does not seem to function. Bypass module is connected to the OBD2 wire (purple), and the power. If i press any buttons on the remote all it does is make my remote starter module "click" like a relay activating. But nothing will happen. Truck will not start, lock, or unlock. bypass module firmware 3.01.

0

What is data link?

2006 silverado 1500, using crimstopper ps04-g5 remote start. I do not understand the connection. I got all the ignition wires done, it was connected to the OBD2, grounded. I had power to both the remote start and the bypass module however it still did not work, instead it blew my ignition!

 

using INT-SL+ bypass. the intructions I recieved from the amazon seller said 

 

Remote start power harness: Pre-wired to plug directly into the ignition wires in your car using the quick connects supplied with the kit. Remote start 12-pin harness: You will only use the ground (black) wire and the grey wire. The rest are not used. Remote start 3-wire door lock harness: Not used INTSL 4-pin harness: This will plug in to the remote start INTSL 14-pin harness: You will only use the pink and purple wires.    Was i suppose to use more?

1

Why does my INT-SL+ not turn on the rear defrost in my 2008 Trailblazer?

I installed a INT-SL+ into my trailblazer along with a Ultrastart 1280pro remote start unit connected via data wire. All works fine except that the INT-SL+ will not turn on my rear defrost automatically when remote started. The vehicle fitment chart says it will turn on rear defrost when the engine temp is 0C or below... it's been -10F most of the week but my rear defrost has never automatically turned on? did I miss something?

1

03 Tahoe INT-SL+ not programing

The red light stays on and trips the security when i try to program. Service # 002102 043231 HW V: 2 Firmware vr 3.01 date 12/2013 Where do i connect Pink wire that goes to car ignition?

1

Does the INT-SL+ monitor all the doors on 06 Chevrolet Trailblazer or just the fronts D/P

Hello, I purchased an INT-SL+ in to install on my 2006 Chevrolet Trailblazer. It says that it monitors the door status however it does not detail if it is all of the doors, inlcluding tailgate of if it is only the front 2 doors. I have been told that most modules wil only monitor the front 2 doors. Can you please let me know if I will have to run wires to all the doors so that the alarm will go off if either of them are open.

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer