I am trying to get the Evo-All with the AUDT1 to work in my 2014 SQ5. The problem is during programing. I get to the point of all 3 lights flashing, then solid red, then I get flashing red every 1 second instead of red and yellow flashing. I put a new battery in the remote, and tried again. The second time, I got the red and yellow flashing, so I did the Decrypt. I was able to activate the Autostart with 3 lock butttons, but the car won't start without putting the key in the keyport. I get a red light, then a click and yellow light, then a red light. Then a red blink 3 times. The car doesn't start, so the 3 red is no tach signal, which makes sense. If I put the spare key in the keyport, then press 3 locks, the car starts right up. I think the decrypt didn't work. I tried a master reset, and retry configuration, but now I can't get the red and yellow again. I have tried 5 times, and can't get a key read off the keyport. iI have connected the t cable to the keyport, the brake cable, and the 2 canbus wires to the steering column can bus wires. When the EVO-ALL is trying to read the key, the car will show a Parking Brake Malfunction, the HVAC turns off and back on, then gives another Parking Brake Malfunction, then shows a red light, then a flashing red light. Not sure why the controller won't program correctly. Does anyone have any ideas?
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
