Trying to program the EVO-All for my 2013 F150 for stand alone. I have updated the firmware and turned on the stand-alone option. I have connected the yellow ignition wire to the t-harness. I have connected the light blue and light blue/black wires to the corresponding wires. I have correctly connected the Can-high and Can-low wires and have tested them and I am getting about 2.5 volts through each wire when the ignition is turned on. When trying to do the data portion of the programming to the unit, everything goes correctly until the blue light goes out. It comes back on but stays solid and does not flash at all. I read in one of the answers on a different question that the data progamming can be skipped and go straight to the key programming. I follow those directions and the red and blue lights do not blink once I put the first key back in and turn the ignition on. I realized after reading the responses to another question that the red connector is keeping my ignition on even when the key is removed. Programmed the keys with the red connector removed from the evo-all and the red and blue lights flash like they are supposed to but the remote start still does not work. Any help would be greatly appreciated...its about to be really cold here for the next week...
Also...just fyi...your service page says that your technical support by phone is open until 8:00pm est on weekdays but your answering service says its done at 6:00pm est...
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
