I have a 2017 Kia Sedona (automatic transmission) that got broken into. The criminal trashed the ignition system. Rather than replace it, I converted it using the Ghost Key by JDI. The button works as follows: wave the key fob over the antenna, then push the start button once. This turns on the radio. Pushing the start button a second time turns on the gauges. A third press will turn everything off. To start the vehicle, wave the key fob over the antenna, put your foot on the brake, and press the start button. I have everything installed according to the install guide (here), but when I get to the programming section on page 5 (program 2 without EMS com wire) I get stuck on number 4. I've tried pushing the start button (single and double push) and starting the vehicle, but the light never flashes. I just stays solid blue or turns off completely. Should I use the program sequence for the push to start model or is there another way of programming the module?
Any help is greatly appreciated.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
