User

I have a 2008 Dodge Gand Caravan SE and I am following the guide #5131 Most of the wires are connected to from the remote starter to the evo-all. (Without Data Link) wires that are not connected to the evo-all are: Pink/black-hood status (not connected, remote starter hood status wire and switch connected directly to vehicle hood, vehicle does not have a factory hood switch) orange/black- sliding door right (not equipped on vehicle) orange- sliding door left ( not equipped) white- trunk status ( not available on remote starter) Everything else is connected! I got the wiring colors from wirecolor.com, and the Can High wire has different colors compared to the guide? I followed the fortin guide NOT the wirecolor.com. starter wire red/blue (evo-all) connected to purple (starter output-starter side) thicker guage wire from my remote starter wire. ignition-yellow wire (evo-all), Comm2-yellow/red (evo-all) connected to remote starter ignition 1 wire (thick guage wire) connected to cut wire red/white vehicle side immobilizer connecter. grey/black-Can 2 Low (evo-all) connect to white/light blue vehicle immobilizer wiring harness grey-Can 2 High (evo-all) connected to white/grey vehicle immobilizer wiring harness Yellow/blue-NO2 (evo-all) connected to light blue/ red of the vehicle immobilizer harness yellow/green NC2 (evo-all) connected to cut wire connector side of vehicle immobilizer harness I followed the programming procedures in the guide, the blue led does not flash after step 3 ( IGN ON RUN) the blue led just turns off . when I proceed with step 4 (IGN OFF) blue led turns turns back on like in step 1. i have tried to remote start, the remote starter works and hear its internal relays, with confirmaton on remote key fob. Vehicle does not start? I do not know if the Evo-All is programmed or not? Evo-All hardware Vr. 6 firmware Vr. 4.18 how many tries do I get to program the evo-all for the immobilizer on the vehicle? do I need to buy the flash link updater, ot reflash the evo-all? please help!