I am working on a 2008 charger, chose to use the evo-chrt4 for stand-alone installation. In the manual that came with the evo-chrt4 it says "for vehicles 2010 and less cut the vehicles ignition" which is fine. but in the manual it shows a picture of the "YELLOW" wire being in the t-harness.. my t-harness does not have a yellow wire. i called and all the guy could tell me was that i had the wrong harness cause only the t2 harness is supposed to have the YELLOW wire.. i just checked the vehicle, it does not have a yellow wire..
So. according to the instructions i am supposed to cut a non-existant yellow wire in the T-Harness?!?!? I have looked over the site fairly well, and have seen in all the instuctions pertaining to the t-harness that there is supose to be a yellow wire. i have also found that this wire being cut is needed to allow you to shift the the car from park.
I have verified the part number listed on the t-harness is "evo-chrt4" the installation guide that came with the unit is revision 20130215(which appears to be the newest revision). and the service number on the evo all that i am using is 001a06 238084 (not that the service # matters as i feel that the error is in the manual, and not something to do with the unit.. also i could not find a service number on the t-harness, is there one?
thank you for you time.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
