I am a consumer- there are no Fortin installers near me, so I'm on my own. I purchased the EVO-NIST3 and installed it correctly (I think), but it isn't working. When I have the power off, I plug in the module while pressing the program button as instructed, release at one blue light. I then press the start button and the module's lights go out. No lights until I press the start button again- the blue light comes back. Nothing works.
As I understand it, the module should already be prgrammed, and it's just plug and play, right? I installed the harness. Did I miss something? Thank you.
EDIT: I just realized I did not install the hood switch and valet switch. That wire is not going to ground. Would that cause the blue light to go out instead of flash during programming? It looks like the whole unit went dead as soon as I pushed the start button. Thank you.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
