Evo-all, Service #001A106 607958, hardware version 6, date 01/2016, Firmware 71.35, C1 and D1 ON. Stand Alone with T harness.
2013 Ford Edge, no hood pin or auto lift gate.
Wiring installed per guide 34421. Installed all 20 pin connector wires as shown in guide including A17 and A18 with exception of A14, hand brake. I am unclear where or what the relay is, I did find a fuse relay 85 but it is empty and not used. Spoke to tech support and was told that this was not needed.
During programming all goes as plan through step 8, first key second time, red and blue lights flash (did not try to count how many times so I am not sure if 10 times, but looked good). The blue light comes on and then turns off before I remove the key (thought this was the issue so I removed key faster before the blue light went out and this did not help solve the problem.
3X remote activates locks, check engine light comes on, car does not start. When I key start the car it will not turn off until I remove the data connector.
This seems to get so close to working that I am sure it is a minor fix, loose connection, but I am not sure where to concentrate my fix.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
