I Have recently installed an EVO-ALL with EVO-START into a 2016 VW Golf Sportwagen. Regular Key-start.
With factory settings A1-A11, D1, D2(factory alarm) C1 & H2(evo-start) all turned ON. The car seems to start at random with this setup it will work sometimes and then will not start on an immobilizer error. Once I get the error it will not remote start again.. but then if I manually cycle the key on/off in the ignition, get out of the car and remote start it will usually work again.
If I wrap the key in series from the evo-all to the transponder (D4 white/green wire from evo-all module directly to key wrap and then out of key wrap to transpoder wire) and then turn OFF option A3 the car remote starts perfectly every time. but will also start manually with a NON-CHIP key. (always sending transponder key)
The key wrap has been checked and redone (just to make sure) as has all the wiring and everything is good. Firmware version is up to date as recommended. I even tried another evo all module to make sure and got the same result.
I'm really not sure what else to check at this point, But with A3 on and white/green wired in parallel with the wrap/transponder I get very random starting results will work several times in a row and then not start on an imoblizer error the evo-start is less consistant than than 3x lock on the oem remote but both are not near consistant enough.
Is it possible to wire this set up with a transponder ring/wrap instead of the cut transpnder wire on the car? Not sure if that would help provide more consistant results?
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
