Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

13/01/2025

 Subaru G M (16110Pts.)

1

2020 FORESTER

I installed Evo-One on 2019 (2020 model) Subaru Forester (PTS). The rear edge of the fuse box was not as shown in the diagram... And I did not find any CAN wires there. Then I connected the CAN wires to the red and blue wires in the connector, next to the IMMO DATA wires. I programmed it successfully, but when trying to start the remotely, only the ignition opened... The starter did not turn (the starter wire is not indicated in the diagrams). Then, I connected the starter wire to the gray-red wire next to the IMMO-DATA wires. The engine started, but the doors did not open from the standard remote control. After that, I connected the CAN wires to the white and black wires in the connector on the back of the dashboard. And already opened the doors...
Login to reply View 0 answer(s)

27/02/2024

 Subaru Joshua Swenson (1660Pts.)

0

2020 Subaru Forester install questions

1. In this thread from a while ago, it was said that enabling 3x lock is not recommended for a 2019. Does this still apply? https://fortin.ca/en/qa/90775/LockLockLock-Forester-Sport-2019/ EDIT: May have been fixed in firmware 1.24 AKA 0.60? 2. Guide 98941, page 7. I'm probably over analyzing this, but I assume for the Yellow/Red and Yellow/Green wires, the illustration is saying to connect the respective wires together. Is that correct? I figured there would be a black circle on it if that was a case. I initially thought this was a spliced wire from the factory. 3. Will there be issues if I use an Omega RF kit and have to use firmware 0.44? Thanks all!
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue