Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

25/09/2022

 Nissan Samione90 (130Pts.)

0

Hello! Which EVO kit and T-HARNESS will fit my car? Nissan Teana L33 2014 Europe.

Эта машина на платформе Altima! Но только европейской сборки. Мне интересно, куплю ли я комплект EVO All NIST4. Подойдет ли распиновка проводки и жгута для моего автомобиля?
Login to reply View 1 answer(s)

02/05/2021

 Nissan Eric Laing (390Pts.)

0

2016 Juke parking light wire resets car features

I have 2 2016 Nissan Jukes, yes, his and hers. My starter works fine and turns on the parking lights (brown wire to purple wire of green pin1 at BCM connector), when I put the brown to purple in my wifes car, the lights don't turn on and it resets the radio/time to factory, every time. Again, identical 2016 Jukes. I am NOT pulling the starter out of her car as where I have it tucked in takes a long time to get at. Verified 12v at purple wire with manually turning on the parking lights but when remote started the Fortin brown wire has nothing. Ideas?
Login to reply View 3 answer(s)

02/12/2020

 Nissan Wesley Bridges (140Pts.)

1

2015 Nissan Altima Ignition Ignition 2 wire

Not a question so much as an update to your notes. On the installation instructions it shows Ignition 2 as Pin 9 Black 24 Pin plug as a Pink wire. Vehicle I had it is not a Pink Wire it is Brown but when tested goes + when PTS is hit for ACC or IGN.
Login to reply View 1 answer(s)

30/04/2018

 Nissan Jehad Alyousef (190Pts.)

0

where does the A8 (dark Blue) wire connects on 2015 Nissan Armada Intelligent Key?

I just want to make sure that the meant by "The Driver Door Pin" where the A8 Dk. Blue wire connects is that switch located at the body frame and controls the inside capin lights? is this is the correct interpretation? Thanks
Login to reply View 1 answer(s)

28/01/2018

 Nissan Nodier Vallejo (1030Pts.)

0

dark blue wire, driver door trigger - does not work

I have a 2011 nissan rogue intelligent key, I installed an evo one, everything works perfect, except the trigger of the driver's door (auto lights shut down ) dark blue cable, connect this cable to the negative of the door trigger, exactly as the instructions say , but I have the problem that when starting the remote start the vehicle turns on but after 2 seconds it turns off, check the problem and I find that when the remote starter start the dark blue wire  gives a constant negative discharge and the sensor of the door trigger shows as if the door were open, I do not really understand what this dark blue wire is for and what function it has, disable it and the car lights normal, my question is what should I do or what is the problem, or I must configure thanks.

Login to reply View 1 answer(s)

14/01/2018

 Nissan James Schmidt (130Pts.)

0

Are Lock unlock A2 and A3 optional 2010 altima PTS EVO All

If A4 and A5 are hooked up, do A2 and A3 need to be hooked up, and vice versa?
Login to reply View 1 answer(s)

03/01/2017

 Nissan Vincent McShane (130Pts.)

0

I cannot get Flash Manager to save options with EVO ALL

Have EVO-ALL NIST 1, service #001A06680216 and Flash-Link-4, service #002504 043308 for a 2013 Nissan Maxima PTS. Flash updated module to hardware version 6, firmware version 72.24. When I try to save options for 3X lock in flash manager the device immediately disconnects and message appears: "The current unit does not support this feature". How can I get module to accept changes?
Login to reply View 1 answer(s)

12/01/2016

 Nissan jordan maxey (190Pts.)

1

Evo-one on 2010 sentra does not remote start

I followed wirecolor.com instructions and got the evo-one to program CAN and all that so i know im on the right track, but when i push lock three times on factory remote it does not start
Login to reply View 2 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue