Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

1

Anyone know why 2009 Mini Cooper s will not shut off with int-bmw-2 installed

I installed a remote start , evo-all and the int-bmw-2 in my wife's 2009 Mini Cooper. Evo -all seams to have programmed. However the int-bmw-2 would not let the vehicle start for about the 1st 5 minutes after installed. Once it was started with the key in the slot and the button pushed, it would not turn off. I could remove the key from the slot and it would still run. I finally had to disconnect the int-bmw-2 ribbon cables and hook the ignition up direct to turn the car back off. Anyone have any ideas or could I have a bad int-bmw-2.

1

Which directions to use int-bmw2 or evo-all

I contacted support today to ask which directions to use for 2009 Mini Cooper , there are two differences, BMW says to hook the brake though the BMW unit and hook the rf loop through a white/red and white/blue wire on the evo-all. The evo-all says to hook the brake to the evo-all and to use the white two pin connector as the rf loop. I was told to use the BMW directions. I hope this is right the support tech told me to use 7971, that came up as the BMW directions. He was to busy talking over me when I tried to confirm this with him, no where on the BMW directions is 7971 listed and no where on the evo-all directions does it say to refer to the the BMW directions. Can you confirm that this is correct, the tech was kind of rude.

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue