I have installed an Evo-All with Crimestopper SP-502 alarm/remote start system and the Evo-all is sending a continuous ignition on thru data signal to the SP-502 unit. This is verified by the key icon on the alarm remote and also the trouble code on the SP-502 when trying to remote start the vehicle. The Evo-All is programmed with firmware version 70.18. The wires are connected per guide number 61111 with the exception for trunk release (A13) which is N/A and Hood Status (A15) which is also N/A for this vehicle. The Evo-All is programmed per guide number 61111. The wiring from the Crimestopper SP-502 was connected to the Evo-All as per guide number 61111 and the remaining wires on the SP-502 were installed per the SP-502 installation manual.
The doors lock and unlock, but the continuous ignition through data from the Evo-All is preventing the SP-502 from setting the alarm, or remote starting the vehicle. I have verified each wire connected is correct per the manuals and wirecolor, vehicle specific instructions. What issues would cause a continuous "ignition on through data" signal from the Evo-All?
Thanks in advance for your help!
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
