Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

Rf411 not responding

I installed an evo one and rf411 in a honda civic 2012 and it worked perfectly while i was installing it. However, while routing the antenna, I removed the cable from the antenna side to make the routing easier and re attached it after. Now the factory remote 3x start works but the rf kit remote is not accepted by the antenna. Also there is no lights coming on the antenna. I tried plugging it in to see if the light comes on, reprogrammed the evo one, tried the antenna button, tried putting the antenna in programming mode but the led doesnt come on at all.

0

Rf411 not responding

I installed an evo one and rf411 in a honda civic 2012 and it worked perfectly while i was installing it. However, while routing the antenna, I removed the cable from the antenna side to make the routing easier and re attached it after. Now the factory remote 3x start works but the rf kit remote is not accepted by the antenna. Also there is no lights coming on the antenna. I tried plugging it in to see if the light comes on, reprogrammed the evo one, tried the antenna button, tried putting the antenna in programming mode but the led doesnt come on at all.

0

Key takeover not sending update to RF642W keyfob

2009 Honda Pilot, Evo One, RF642W. All functions good, remote range good, but for some reason, key takeover is not updating the key fob. I've tested on both remotes. The green led blinks, indicating the remote start is active even after unlocking, inserting key, and driving away. The green led on the fob continues to blink while driving. All other functions are working, i.e., doors lock on remote takeover and brake pedal. A bit annoying to have the led blink and also concerned that this will drain the remote battery prematurely. The only way I can get the led to turn off is to press [-] twice to request status. In that scenario, the fob beeps twice indicating 'disarmed', and then the led turns off. I have to do this procedure every time I use remote start.

0

Trouble programming Evo One for 2015 CRV PTS

2015 CRV PTS. Stuck at step 5 no yellow or blue rapid flash after double PTS press. Thank you

0

2018 Civic PTS, EVO ONE with T harness Crank but no start on 1st attempt, Lights flash 4 times

I programmed the module and hooked it up, Car remoted started fine. The 2nd time I tried to remote start after setting ready mode the car cranked but did not start (lights flash 4 times). After 10 seconds it attempted again and started. This has been going on for a week. sometimes it starts, sometimes on the 2nd attempt, sometimes not at all . Once, I couldnt shut the car off and had to disconnect the module in my work parking lot . I have reset and reprogrammed the module, Verified all T harness conections are tight and no bent pins and it does the same thing. I have emailed Tech support with no answer .

0

Car starts on 3 lock press of OEM Key, but after start it won't respond to OEM Remote

I have installed the EVO-ONE using T-Harness (TAR-ONE-HON2) on my 2016 Honda CRV, the car starts with OEM remote, but after the start the functionality of the key is lost, I can't unlock the vehicle or engage 3-lock sequence to shut off the remote starter.

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue