Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

evo ride wiring says to yellow goes to ignition to car

09 ford e350 van trying to install compustar cs700 with evo ride module with 3 or higher hardware,preloaded all in one firmware no key required.Using connection 2 It says connect yellow wire to ignition which one ignition 1, pats ignition, purple/white wire goes to pats rx data at transponder pin3 connector and yellow/black wire goes to pats tx data at transponder pin 4 any help would be appreciated thanks.

0

will evo ride work on a 2009 ford e350 van,does it need to be programed

Will evo ride work on a e350 ford van and what is needed.

0

will my evo ride work with my 99 ford expedition

hi my name is alex. I cant seem to wire the evo ride with software level 3. after wiring the bypass module up i cant seem to get the red light to blink and am unable to program, please help

2

Aftermarket remote control for FSA-216 EVO-Ride combo

I want to know if any aftermarket remote control fob are compatible with the FSA-216 remote starter. I am guessing its a one way. Cant find any documentation on this. FSA-216 does not seem to exist, although i have one in my car. Or where can i get replacement OEM remote controlers.

0

2011 F-150 EVO-Ride won't program keys

I need help...remote start works fine with key in the ignition...but when trying to program the keys I get 10x flashes when i insert the second key. now...both keys are factory...my truck is unlocked for programing and i've tried doing every possible thing I've seen in these forums. BTW keys are 80-bit and I'm using an evo-ride v4. Please help

1

evo ride flash after second key

evo ride flashes 10 times when turn the second key on. not programming tryed many ways to try programming it for 40 bit vehicles evo ride vr2

0

evo ride will not complete program

The evo ride is connected to an 80bit key 2013 F150 ford (verified with voltage test) Module goes through all the programing/ blinking with the two keys. When i activate the remote starter to complete the programing the module led stays red and does not blink. The module label states it has firmware 2.xx.

1

Bypass for 2011 Ford Ranger, 80-Bit

I'm working with a customer who has a 2011 Ranger with the 80-bit key. EVO-RIDE only lists 40-bit in the compatibility chart. EVO-ALL sas it's compatible with that vehicle, but makes no mention of either key type in the compatibility chart. So....Which is the right module to use for a 2011 Ranger 80-bit? Thanks!

21/04/2014

Ford (Pts.)

1

Evo-Ride + Remote Start pair to Ford Fiesta 2014

I just bought an Evo-Ride to a Ford Fiesta 2014 (without start button). I found that www.fortinbypass.com/datalink/ page was removed. I found that Evo-All have support to 3 datalink protocols. Does the same happens with Evo-Ride? I need to know what Remote Start Systems have support to Fortin Datalink. Thank you.

1

2012 Expedition SA keys EvoRide wont program

After fighting like an idiot, I finally came to the FAQ where it says, even with SA keys it might be a 40 Bit. YESSSSSSSS column looks like a 2009 F250 it all makes sens. So I program Evo Ride like a 40 Bit. All sequence goes good, led flashes, hit brakes, remote shut down. Try to star truck it starts. yey . Attach byass under dash ect. Try again , No Start. Being a 40 Bit I decide to try a Key Overide All. did same truck started righ away on programing sequence. attach modul under dash ( very softly not to pull any wires away. 0 truck don start again Theft light is flashing like it should with wrong transponder.

1

Evo Ride don t program Taurus 2010

Can t find version 2.04 on flashlink 3.31

2

2007 Ford F-150/EVO-RIDE programming difficulty, any tips?

Hardwhear Vr 3.0, Firmw 2.03 Ser No 000903 023639 150 programming: 3 seconds on 1st key, 3 seconds off, 3 seconds ON 2nd key, key OFF immedicatly activate r emote starter - maybe taking longer than 3 seconds? Fords dash red LED begins rapid fladsh, truck wont start - could my remoter starter just be taking too long? thanks, Derek

1

Having trouble programing evo-ride to ford f150

I have a 04 f150 and everytime i go through the programing for the keys and then start the remote starter the lights come on like its fixing to start then the red truck led starts flashing and it doesnt trun on. i have one original key and another one i got made at walmart they just put int in a machine and cloned it or somthing could this affect the programing since maybe the system thinks it is the same key instead of another one. also the remote starter is working because when i have the key in the igniton and without being truned forward the remote starter will turn the truck on and off. is here another trick to programing the evo-ride to this truck that is not specified in the instrucition sheets?

2

2007 Ford F-150/EVO-RIDE programming difficulty, any tips?

Hardwhear Vr 3.0, Firmw 2.03 Ser No 000903 023639 150 programming: 3 seconds on 1st key, 3 seconds off, 3 seconds ON 2nd key, key OFF immedicatly activate r emote starter - maybe taking longer than 3 seconds? Fords dash red LED begins rapid fladsh, truck wont start - could my remoter starter just be taking too long? thanks, Derek

0

Car starts 30 second then shut off

Evo ride is connect to Crimestopper D7. The car run for about 30 seconds and shut off. It trys to start again and then shutoff again. I think its not sending a tach signal???? When I program the evo ride I dont get the 10 flashes. But it starts with out the key. Is the ground while running needed?

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue