Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

14/11/2019

 FAQ Robert T (300340Pts.)

6

FAQ: RED LED STUCK ON

When a module is stuck on the RED LED. 

    flash version 0.99 disconnect unit from the flasher and power cycle it in the car (connect/disconnect power connector) connect module back to the flash link and flash whatever firmware you need Turn settings protection OFF if it's on and SAVE the options. Reset the unit following the reset procedure. (this cannot be done while module is connected to the flash link) : https://fortin.ca/en/qa/50193/faq-how-do-i-reset-my-evo-all?show=50193#q50193 Connect module back to the flash link and enable required options. Reprogram module to the vehicle following instructions in the installation guide.

 

Reasons this happened.

    Unit was connected WHILE doing the install. Unit was disconnected during CAN programming before the blue led started to flash. Power was disconnected while all other connectors were still connected.  during an update or save of options, the flash link lost connection to the module or the internet RF protocols not setup correctly, or RF device not paired to unit correctly. Datalink protocols not setup correctly. Bad ground. Loss of power during writing of data to the module.
Login to reply View 0 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue