Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question

0

Evo all flashed to many times

0

Reset EVO One

I would like to check before I buy a new rf kit and harness if I can reset my evo one and the dcryptor so I can move this to another vehicle please - 002B04008976

0

Decryptor limit on Evo all ?

Decryptor limit on Evo all SN: 001A07361332 is there something I can do?

0

001a07 338367 Can I get you to reset my unit.

Can I get my unit reset please.

0

Flash limit reset

Flash limit reached SN: 001A06339879 Flash link 2 firm:4.05 sn: 002502887766

0

Can you please reset my module SN:001A06165529

Good evening! Can't update my EVO-ALL serial number 001A06165529 firmware 79.05. When updating, it says that the current BYPASS firmware is not compatible with this vehicle. Opel antara 2014 car. I ask for help in solving the problem. Thank.

0

flash link lite

OEM 3X LOCK NOT STARTING 2018 travese (NOW AT FLASH LIMIT)   flash link serial 005202001248 please help

0

OEM 3x Lock not starting 2007 Silverado Classic (now at flash limit)

I'm doing a first time install of the EVO-ONE (SN 002B048051) on my 2007 Chevrolet Silverado Classic 2500 HD Diesel and I followed Guide 61101 Rev 20190723 which stated the bypass FW must be a minimum version of 70.26. The latest version of my flashlink software wants me to use 70.18 (highlighted in green) which did not work so I then upgraded to the latest version 70.39. I found at the latest version the module would not recognize the key programming procedure (all led's flashed at same time when powered on). I then tried going down one FW version at the time (from the latest) and found that 70.34 is the latest version that will work as per the guide and accept key programming without all LED's flashing when plugged in. I'm now stuck at that version and cannot set bypass options any longer since my flash limit has been reached (not sure if not being able to set bypass options is due to flash limit reached or the fact I'm now at 70.34 because I know 70.26 did allow me to set bypass options). Both 70.34 and 70.26 are greater than the guide requires My remote start FW is 1.24 and I had enabled both options 38.2 and C1 along with other options for Diesel etc. According to the guide the 3x lock , heated seats etc should work on the classic and this module but I have yet to see success. When I start the truck with the key I see the yellow light come on showing the key is programmed however I do not see the blue light blink when pressing lock on my OEM remotes. I do have the Fortin Rf642 rf kit on the way and will setup the module to use those however I wanted to enable the 3x lock on the OEM remotes in the meantime. Can anyone point me in the right direction? what FW should I be running and can my module be unlocked so I can flash and configure it please? Is there some other wiring outside of the guide that I am missing? Also can anyone confirm the options that should be enabled to trigger heated seats, remote defrost and heated mirrors? Thanks

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue