Two issues, maybe related to the same answer.
Installed EVO-with CHRT-6 in standalone mode, honk 3x's. When using the remote start it triggers a check engine light, pulling the code indicates the Brake Module is detecting a signal when it should not., 0415 antilock brake invalid signal
I am assuming this has to do with the MUX wire. Does the push to start challenger 2016 up require a mux relay?
Can I follow the same wiring as mentioned in another thread?
Next, just to confirm vehicle take over. When using remote start about 15 minutes after driving, the car rolls the drivers window down partially, turns on the interior lights and dispalys a door open chime and popup on screen. It is very consistant at 15 minutes which i know is the run time for my module. I am wondering if what I am doing is wrong for vehicle take over, or if the mux/check engine light are related to this issue.
Currently, honk three times, car starts, after running a bit I enter the vehicle, note has touch sense doors to unlock, i put my foot on the brake, put in drive and go. Fifteen minutes later the car does above as discribed.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
