installed a 6200 + blade ads into my girlfriend's 2011 civic without a hitch...fortin is giving me grief.
remote start fob was successfully programmed and will operate door locks; but no start - no crank....no switched ignition...nothing.... I also noticed that the fob won't update the door lock status if i change door lock position with oem fob - this is something that occurs in my girlfriend's car.
evo all is connected to cm6200 via 4 pin datalink connector and evo all was programmed successfully no problem (got to flashing blue lights with key in run position). only 1 programming procedure so pretty hard to mix it up with another.
option 4-11 is set to fortin protocol (setting 2) in cm6200....i have verified this with op500
As per connection 4 diagram of evo all install manual i have cm6200 connector CN2 pin 11 (poc5, black) connected to evo all 20 pin connector pin 8 (dark blue) for ground while running and i have verified that POC5 for CN2 pin 11 is set to 0 (GWR) via OP500.
I did come across some apparent situations with other vehicles where evo all 20 pin connector pin 1 yellow was mistakingly connected to vehicle ignition wire (ignition barrel 7 pin connector pin 2 yellow), but can't find any evidence of that when installing evo all in 06-11 civic.
the only thing i can think of is whether or not it's worth trying to loathingly purchase the flashlink updater and switch cm6200 to ads protocol and do the same with the evo all? Other than that i'm at a loss...???
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
