Utilisateur

Following the instructions for programming the blue portion. I hold down the programming button then plug in the data cable and the EVO-All blinks blue, red, yellow, blue and red then repeats. The instructions say it should only blink blue, yellow, red then repeat (not sure if this matters). I then release the button when blue and it says on solid. I plug in the remaining wires and put the key into the ignition and turn it to the ON position. The light goes out for a moment then the blue light starts to flash rapidly as per the instructions. At this point I can put the key into the ignition (in the OFF position) and press the lock button 3 times on my remote and the vehicle will start. I can only get the vehicle to shut off by pressing the lock button 3 times again. Pressing the brake or turning the key to ON and pressing the brake and turning the key OFF will not turn the vehicle off (not sure if that even matters at this point in the programming). Moving on to the red portion of the programming. I unplug all connectors on the EVO-All. Then while holding in the programming button I connect the data cable. Once again I get the blue, red, yellow, blue and red lights repeating. I stop on red and release the button. The red light is now on solid. I insert the first key into the ignition and turn it to the ON position. The red light goes out while the yellow light comes on solid. I wait 3 seconds and turn the key to the OFF position. The yellow light goes out while the red light comes back on solid. I then insert the second key into the ignition and turn it to the ON postions. The red light stays on solid. I wait 3 seconds and turn the key to the OFF position and remove the key. The red light is still on solid. Finally I press the program button and the red light flashes once, I then press the lock button on the remote 3 times (all within the 5 second alloted time) to activate the remote start. The red light does not flash 10 times as per the instructions. The light just stays on solid and the vehicle will not remote start. Any help would be appreciated.